Wire

Machine for drum assembling. This machine has been designed with the precise aim of minimizing as much as possible the time needed to measure and wind cables on drums. This extremely simple, robust and safe machine allows only one operator to carry out all the daily measurements in a cable warehouse. The machine is easy to handle and suitable to move along an electric cable storage rack.

FEATURES OF THE DRUM WINDER

• Steel SHAFT with cones.
• DRUM BLOCKING CONE for rapid clamping.
• DRUM LOADING through insertion of the shaft into the drum hole while the machine is moving
• DRUM LIFTING with manual hydraulic cylinder pump working on an oil dynamic cylinder.

FEATURES OF THE MEASUREMENT DEVICE

• Measurement device for round cable with diameter from 2 to 50 mm (margin of error +/- 1-2%).
• Rubber coated metric wheel for a greater grip and better measuring.
• Mechanical meter counter with manual reset.
• Manual cable layering through HIWIN guides and sliding blocks for better sliding and higher resistance.
• Layering handle operated at the side of the machine, in accordance with accident prevention regulations.

CONTROL PANEL

• Power supply 220 V – 50 HZ (optional: 380 V).
• Speed adjustment with INVERTER and potentiometer from 0 to 70 rpm.
• 1,1 KW gear motor with integrated control panel with emergency stop button on the coils, indicator lights and control push-button strip.
• Electric handle with START button to wind the drum (very practical because it enables to control winding and layering with one single control).

TECHNICAL CHARACTERISTICS